Dynamic Rhino2 (scooter flash) fault code 2 flashes: Low battery fault

Code2 flashes
MeaningLow battery fault
ControllerRhino2 (DS90 / DS120 / DS160) – Scooter / R-Series flash type CONFIRMED
How it showsStatus LED / battery gauge flashes. Scooter type 250ms on/500ms off/2s break. HHP shows 4 digits: first 2 = flash code, last 2 = sub-code. Wizard log holds last 16 faults. R-Series type 140ms on/400ms off/2.4s break (both timings on the dealer workshop poster)
Likely part needed: Battery INFERRED – only if the checks below point to it. Find it ›

Likely causes

Batteries flat (below ~16.5V) or bad battery wiring

Step-by-step checks

  1. Recharge
  2. Check battery, connections and wiring

Switch off before unplugging anything. If the code stays after these checks, get a trained technician to look at it.

Parts that usually fix this INFERRED

Matched by ScootScan from the fault description to parts listed for models that use this controller. Do the checks first – many faults are fixed by charging, a loose plug or a reset – and check the part fits your model before ordering.

12 volt battery (catalogue text '79AMP', code 12V100AH) · part no. 12V100AH
Battery listed for the Drive DeVilbiss Sport Rider
Find this part on Amazon UK ↗Find this part on eBay UK ↗
Battery cable (-) · part no. C18-062-00901
Battery listed for the Drive DeVilbiss King Cobra
Find this part on Amazon UK ↗Find this part on eBay UK ↗

Some links may be affiliate links; we may earn a small commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases.

Models using this controller

Other Dynamic Rhino2 (scooter flash) codes

1 flash · 2 flashes · 3 flashes · 4 flashes · 5 flashes · 6 flashes · 7 flashes · 8 flashes · 9 flashes · 10 flashes

All Dynamic Rhino2 (scooter flash) codes ›

Source: www.manualslib.com/manual/3228987/Dynamic-Rhino2-Ds90.html?page=126 ↗

Summarised from public manuals. Always check the product's own manual before any repair.