Dynamic SHARK fault code 6 flashes: Parkbrake 2 (usually right) released manually, not connected to the SHARK, or short circuit in the parkbrake connection

Code6 flashes CONFIRMED
MeaningParkbrake 2 (usually right) released manually, not connected to the SHARK, or short circuit in the parkbrake connection
ControllerSHARK powerchair control system (Remote + Power Module) CONFIRMED
How it showsFault indicator on the SHARK Remote flashes a number of times, pause, repeat

Likely causes

Parkbrake released manually; parkbrake not connected or shorted; cables loose or damaged

Step-by-step checks

  1. Enable the parkbrake, then turn the SHARK off and on
  2. Check the motor cables are not loose or damaged
  3. Contact your dealer

Switch off before unplugging anything. If the code stays after these checks, get a trained technician to look at it.

Models using this controller

Other Dynamic SHARK codes

1 flash · 2 flashes · 3 flashes · 4 flashes · 5 flashes · 6 flashes · 9 flashes · All other flashes

All Dynamic SHARK codes ›

Summarised from public manuals. Always check the product's own manual before any repair.