Dynamic SHARK fault code 1 flash: Route / temperature: motor current at maximum for too long, or SHARK Power Module too hot
Code1 flash CONFIRMED
MeaningRoute / temperature: motor current at maximum for too long, or SHARK Power Module too hot
ControllerSHARK powerchair control system (Remote + Power Module) CONFIRMED
How it showsFault indicator on the SHARK Remote flashes a number of times, pause, repeat
Likely part needed: Motor INFERRED – only if the checks below point to it. Find it ›
Likely causes
Motors not strong enough for the route (too steep); wheels rubbing on the frame; faulty motor(s); Power Module overheated
Step-by-step checks
- Turn off the SHARK, let it cool, turn it back on and choose another route
- Make sure the wheels turn freely
- Have the motor(s) checked by a service technician
- If too hot wait a few minutes and try again, and if it happens often contact Dynamic
Switch off before unplugging anything. If the code stays after these checks, get a trained technician to look at it.
Parts that usually fix this INFERRED
Matched by ScootScan from the fault description to parts listed for models that use this controller. Do the checks first – many faults are fixed by charging, a loose plug or a reset – and check the part fits your model before ordering.
Motor
General search – no specific part number is listed for these models yet, so check fit carefully.
General search – no specific part number is listed for these models yet, so check fit carefully.
Some links may be affiliate links; we may earn a small commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases.
Models using this controller
Other Dynamic SHARK codes
Summarised from public manuals. Always check the product's own manual before any repair.