Not stated CareCo Stratus beep codes 1-10 fault code 5 beeps: Right (RHS) brake in freewheel mode, or brake / wiring fault

Code5 beeps CONFIRMED
MeaningRight (RHS) brake in freewheel mode, or brake / wiring fault
ControllerCareCo Stratus beep codes 1-10 UNVERIFIED
How it showsJoystick LEDs flash and the horn sounds; the beep code (1 to 10) is read from the Troubleshooting table in the manual
Likely part needed: Brake, Freewheel lever INFERRED – only if the checks below point to it. Find it ›

Likely causes

The RHS brake is in freewheel mode; or the RHS brake and/or its associated wiring has a fault.

Step-by-step checks

  1. Switch off, put the RHS brake (red lever) in drive mode, switch on
  2. If it still beeps, contact CareCo

Switch off before unplugging anything. If the code stays after these checks, get a trained technician to look at it.

Parts that usually fix this INFERRED

Matched by ScootScan from the fault description to parts listed for models that use this controller. Do the checks first – many faults are fixed by charging, a loose plug or a reset – and check the part fits your model before ordering.

Red freewheel lever (LHS / RHS)
Freewheel lever listed for the CareCo Stratus
Find this part on Amazon UK ↗Find this part on eBay UK ↗
Brake
General search – no specific part number is listed for these models yet, so check fit carefully.
Find a brake on Amazon UK ↗Find a brake on eBay UK ↗

Some links may be affiliate links; we may earn a small commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases.

Models using this controller

Other Not stated CareCo Stratus beep codes 1-10 codes

1 beep · 2 beeps · 3 beeps · 4 beeps · 5 beeps · 7 beeps · 8 beeps · 9 beeps · 10 beeps

All Not stated CareCo Stratus beep codes 1-10 codes ›

Source: www.careco.co.uk/media/manual_documents/1771451758_IFU_Stratus_Powerch ↗

Summarised from public manuals. Always check the product's own manual before any repair.