CareCo Alpina – fault codes, parts & serial label
Typemobility scooter
Years / revisionIFU 2504-01 (product code MS03010029.PC)
ControllerPG S-DRIVE 120A (manual spec table) CONFIRMED
Fault codes (7)
From the Alpina code set. All Alpina codes explained
| Code | Meaning | Checks |
|---|---|---|
| 1 | Battery voltage too low / battery fault | Charge the batteries for 8-12 hours. If it persists: Contact CareCo. |
| 2/3 | Motor wiring fault | Contact CareCo. |
| 4/5 | Freewheel mode / brake fault | Switch OFF (remove key where fitted). Put the scooter in DRIVE mode. Switch ON. If it persists: Contact CareCo. |
| 6 | Charger connected | Disconnect the charger from the scooter. |
| 7 | Throttle obstructed / throttle or speed-pot fault | Switch OFF. Release the throttle lever / clear the obstruction. Switch ON. If it persists: Contact CareCo. |
| 8/10 | Controller fault | Contact CareCo. |
| 9 | Controller fault | Contact CareCo. |
Serial code label
WhereProduct identification label is located on the tiller (CareCo user manual, product identification section). CONFIRMED
Label readsLayout and number formats not recorded - no label photo seen yet.
Parts (4)
| Part | Part no. |
|---|---|
| Battery | |
| Charger | |
| Motor | |
| Wheels and tyres |
Summarised from public manuals and supplier listings. Always check the product's own manual before any repair.