PG S-DRIVE 120A Alpina fault code 1: Battery voltage too low / battery fault

Code1 CONFIRMED
MeaningBattery voltage too low / battery fault
ControllerAlpina CONFIRMED
How it showsFlash code on the tiller display
Likely part needed: Battery INFERRED – only if the checks below point to it. Find it ›

Likely causes

The battery voltage is too low; the battery and/or its wiring has a fault.

Step-by-step checks

  1. Charge the batteries for 8-12 hours
  2. If it persists: Contact CareCo

Switch off before unplugging anything. If the code stays after these checks, get a trained technician to look at it.

Parts that usually fix this INFERRED

Matched by ScootScan from the fault description to parts listed for models that use this controller. Do the checks first – many faults are fixed by charging, a loose plug or a reset – and check the part fits your model before ordering.

Battery
Battery listed for the CareCo Alpina
Find this part on Amazon UK ↗Find this part on eBay UK ↗

Some links may be affiliate links; we may earn a small commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases.

Models using this controller

Other PG S-DRIVE 120A Alpina codes

1 · 2/3 · 4/5 · 6 · 7 · 8/10 · 9

All PG S-DRIVE 120A Alpina codes ›

Source: www.careco.co.uk/media/manual_documents/1781793497_IFU_Alpina_scooter- ↗

Summarised from public manuals. Always check the product's own manual before any repair.