CareCo Frontier fault code 10: Battery voltage too high

Code10 CONFIRMED
MeaningBattery voltage too high
ControllerFrontier UNVERIFIED
How it showsFlash code (diagnostic light)
Likely part needed: Battery INFERRED – only if the checks below point to it. Find it ›

Likely causes

Excessive voltage applied to the controller.

Step-by-step checks

  1. Switch OFF
  2. Wait 60 seconds
  3. Press and hold the battery-pack circuit breaker (under the front rubber cover) for up to 5 seconds
  4. Switch ON

Switch off before unplugging anything. If the code stays after these checks, get a trained technician to look at it.

Parts that usually fix this INFERRED

Matched by ScootScan from the fault description to parts listed for models that use this controller. Do the checks first – many faults are fixed by charging, a loose plug or a reset – and check the part fits your model before ordering.

Battery
Battery listed for the CareCo Frontier
Find this part on Amazon UK ↗Find this part on eBay UK ↗

Some links may be affiliate links; we may earn a small commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases.

Models using this controller

Other CareCo Frontier codes

1 · 2 · 3 · 6 · 7 · 8 · 9 · 10

All CareCo Frontier codes ›

Source: www.careco.co.uk/media/manual_documents/1695801940_230721.3_CareCo_Fro ↗

Summarised from public manuals. Always check the product's own manual before any repair.