CareCo Micromus – fault codes, parts & serial label
Typefolding mobility scooter
Years / revisionIFU 2405-02 (product code MS04010014.PC)
ControllerNot stated in the sources checked UNVERIFIED
Fault codes (9)
From the Micromus code set. All Micromus codes explained
| Code | Meaning | Checks |
|---|---|---|
| 1 | Battery voltage too low | Charge the batteries for 6-8 hours. |
| 2 | Battery / battery wiring fault | Ensure the battery connections are secure. |
| 3 | Battery voltage too high | Switch OFF. Wait 60 seconds. Switch ON. |
| 4 | Motor overheated / motor fault | Switch OFF. Wait 10 minutes. Switch ON. If it persists: Contact CareCo. |
| 5 | Freewheel mode / brake fault | Switch OFF (remove key where fitted). Put the scooter in DRIVE mode. Switch ON. If it persists: Contact CareCo. |
| 6 | Charger connected | Disconnect the charger from the scooter. |
| 7 | Throttle obstructed / throttle or speed-pot fault | Switch OFF. Release the throttle lever / clear the obstruction. Switch ON. If it persists: Contact CareCo. |
| 8 | Motor wiring fault | Contact CareCo. |
| 9 | Controller fault | Contact CareCo. |
Serial code label
WhereProduct identification label is located within the battery tray (CareCo user manual, product identification section). CONFIRMED
Label readsLayout and number formats not recorded - no label photo seen yet.
Parts (4)
| Part | Part no. |
|---|---|
| Battery | |
| Charger | |
| Motor | |
| Wheels and tyres |
Summarised from public manuals and supplier listings. Always check the product's own manual before any repair.