CareCo Li-Tech Marathon – fault codes, parts & serial label
Typelithium mobility scooter
Years / revisionIFU 2609-10 (product code MS01010009)
Controller45A S-DRIVE (manual spec table) CONFIRMED
Fault codes (9)
From the Li-Tech Marathon code set. All Li-Tech Marathon codes explained
| Code | Meaning | Checks |
|---|---|---|
| 1 | Battery charge level low | Charge the batteries for 6-8 hours. |
| 2 | Battery voltage too low | Charge the batteries for 6-8 hours. If the fault persists, contact CareCo. |
| 3 | Battery voltage too high | Switch OFF. Wait 60 seconds. Press and hold the circuit breaker on the battery pack for up to 5 seconds. Switch ON. |
| 4 | Controller overheated / overloaded | Switch OFF. Allow the scooter to cool down. Switch ON. |
| 5 | Freewheel mode / brake fault | Switch OFF (remove key where fitted). Put the scooter in DRIVE mode. Switch ON. If it persists: Contact CareCo. |
| 6 | Charger connected | Switch OFF. Disconnect the charger. Switch ON. If the fault persists, contact CareCo. |
| 7 | Throttle obstructed / throttle or speed-pot fault | Switch OFF. Release the throttle lever / clear the obstruction. Switch ON. If it persists: Contact CareCo. |
| 8 | Motor wiring fault | Contact CareCo. |
| 9 | Controller fault | Contact CareCo. |
Serial code label
WhereProduct identification label is located in the battery tray (CareCo user manual, product identification section). CONFIRMED
Label readsLayout and number formats not recorded - no label photo seen yet.
Parts (4)
| Part | Part no. |
|---|---|
| Battery | |
| Charger | |
| Motor | |
| Wheels and tyres |
Summarised from public manuals and supplier listings. Always check the product's own manual before any repair.