CareCo Abilize Ranger Li – fault codes, parts & serial label
Type8 mph class 3 road scooter (lithium)
Years / revisionIFU 2510-02 (product code MS03010028.PC)
ControllerDYNAMIC RHINO II 160A (manual spec table) CONFIRMED
Fault codes (8)
From the Abilize Ranger Li code set. All Abilize Ranger Li codes explained
| Code | Meaning | Checks |
|---|---|---|
| E02 | Battery voltage too low | Charge the batteries for 6-8 hours. |
| E03 | Battery voltage too high | Switch OFF. Wait 60 seconds. Switch ON. |
| E04 | Motor overheated / motor fault | Switch OFF. Wait 10 minutes. Switch ON. If it persists: Contact CareCo. |
| E05 | Freewheel mode / brake fault | Switch OFF (remove key where fitted). Put the scooter in DRIVE mode. Switch ON. If it persists: Contact CareCo. |
| E06 | Charger connected | Disconnect the charger from the scooter. |
| E07 | Throttle obstructed / throttle or speed-pot fault | Switch OFF. Release the throttle lever / clear the obstruction. Switch ON. If it persists: Contact CareCo. |
| E08 | Motor wiring fault | Contact CareCo. |
| E09 | Controller fault | Contact CareCo. |
Serial code label
WhereProduct identification label is located on the seat post (CareCo user manual, product identification section). CONFIRMED
Label readsLayout and number formats not recorded - no label photo seen yet.
Parts (4)
| Part | Part no. |
|---|---|
| Battery | |
| Charger | |
| Motor | |
| Wheels and tyres |
Summarised from public manuals and supplier listings. Always check the product's own manual before any repair.