Dynamic DX2 fault codes
MakerDynamic Controls (Allient NZ) CONFIRMED
How codes showStatus / fault indicator on the DX2 remote flashes a number of times (1 to 12), pause, repeat
Codes (12)
| Code | Meaning |
|---|---|
| 1 flash | DX module / DX BUS communication CONFIRMED |
| 2 flashes | DX accessory / slow-stop CONFIRMED |
| 3 flashes | Left motor (M1) fault CONFIRMED |
| 4 flashes | Right motor (M2) fault CONFIRMED |
| 5 flashes | Left park brake CONFIRMED |
| 6 flashes | Right park brake CONFIRMED |
| 7 flashes | Battery voltage too low CONFIRMED |
| 8 flashes | Battery voltage too high CONFIRMED |
| 9 flashes | DX BUS cable fault CONFIRMED |
| 10 flashes | DX BUS cable fault CONFIRMED |
| 11 flashes | Stall timeout CONFIRMED |
| 12 flashes | Module mismatch CONFIRMED |
Codes without a link are status lights or not used, so they don't have their own page.
Models using this controller
No models are mapped to this controller in ScootScan yet.
Notes: Summary of the DX2 REM42x installation manual section 2.8.3 (p.18-19). Codes 9 and 10: DX BUS cable fault, chair drives slower. Flash 10 at power-on can also be caused by the hazard lights.
Summarised from public manuals. Always check the product's own manual before any repair.