Acorn 130 (T700 board) fault codes
MakerAcorn Stairlifts CONFIRMED
How codes showLetter + number on the display under the seat (A status, C charging, E stop, H hardware, F fatal)
Codes (29)
| Code | Meaning |
|---|---|
| Blank | Asleep / powered down CONFIRMED |
| A1 | Not charging (with beeps) CONFIRMED |
| A2 / A3 | Moving up / down (arm control) CONFIRMED |
| A4 / A5 | Moving up / down (remote) CONFIRMED |
| A9 | Waiting for the hinge CONFIRMED |
| C1 - C5 | Charging (C1 low up to C5 nearly full) CONFIRMED |
| C6 | Fully charged CONFIRMED |
| C7 | Charge voltage too low CONFIRMED |
| C8 | Charge voltage too high CONFIRMED |
| C9 | Battery not found or faulty CONFIRMED |
| E1 | Footrest safety edge – downhill side CONFIRMED |
| E2 | Footrest safety edge – uphill side CONFIRMED |
| E4 | Carriage safety edge – downhill side CONFIRMED |
| E5 | Carriage safety edge – uphill side CONFIRMED |
| E6 | Seat not in riding position CONFIRMED |
| E7 | Battery low CONFIRMED |
| E9 | Key switch off CONFIRMED |
| H1 | Safety circuit grounded to chassis (SW1) CONFIRMED |
| H2 | Safety circuit grounded to chassis (SW2) CONFIRMED |
| H3 | Hinge communication fault CONFIRMED |
| H6 | Hinge didn't reach its end position CONFIRMED |
| F1 | Relay fault CONFIRMED |
| F2 | Brake fault CONFIRMED |
| F3 | Motor over-current CONFIRMED |
| F5 | Battery flat (alarm sounds) CONFIRMED |
| F6 | Final limit overrun CONFIRMED |
| F7 | Overspeed governor (OSG) tripped CONFIRMED |
| F8 | Downhill safety edge active at top stop CONFIRMED |
| F9 | Uphill safety edge active at bottom stop CONFIRMED |
Codes without a link are status lights or not used, so they don't have their own page.
Models using this control board
Notes: Generation matters: the older T502 board uses different E numbers – check the board/age before trusting a code.
Summarised from public manuals. Always check the product's own manual before any repair.